Mazda 6 Installation Instructions Manual page 19

■ Control unit installation
Double-sided
adhesive tape
Main harness
Control unit
Harness (long)
Control unit
Vehicle front
Control unit
Buzzer harness
Harness (short)
Body panel
Double-sided
adhesive tape
1. Affix double-sided adhesive tape to the control unit.
CAUTION
• Always remove dirt or oil because the adhesive strength of
the double-sided adhesive tape weakens.
2. Connect the main harness, harness (short and long) and buzzer
harness connectors to the control unit.
CAUTION
• Make sure the connector is securely pressed in until a click
sound is heard.
3. Peel off the double-sided adhesive tape backing and adhere the
control unit to the body panel of the lower part inside of the
trunk side trim (driver's side).
CAUTION
• Always remove dirt or oil because the adhesive strength of
the double-sided adhesive tape weakens.
19