Telephone Base And Charger Installation; Telephone Base Installation; Charger Installation - AT&T CL83114 Complete User's Manual

Getting started

Telephone base and charger installation

Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 11 for details.

Telephone base installation

Plug the large end of the
telephone base power
adapter into a power
outlet not controlled by a
wall switch.
Raise the antenna.
Route the power adapter
cord through this slot.

Charger installation

IM�ORTANT INFORMATION
• Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
• The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back
of the telephone base.
Plug the power adapter into a power outlet not
controlled by a wall switch.
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
8
Plug one end of the
telephone line cord into a
telephone jack or a DSL filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Route the telephone line
cord through this slot.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
or call
.