Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every ten seconds.
the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press
MENU/
�ELECT
2. Press q
or p
CID
press
/�ELECT.
MENU
3. Press q
or p
CID
/�ELECT.
press
MENU
4. Press q
or p
CID
press
/�ELECT.
MENU
5. Press q
or p
CID
6. Press
/�ELECT to save the setting. You hear a
MENU
confirmation tone.
NOTES:
•
The message alert tone beeps only if all the conditions below are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
•
To temporarily turn off the message alert tone, see page 93.
to enter the main menu.
to scroll to Answering sys, then
DIR
to scroll to Ans sys setup, then
DIR
to scroll to Msg alert tone, then
DIR
to choose On or Off.
DIR
88
Unless you change it,
Remote code
>Msg alert tone
MSG ALERT TONE
>On
Remote code
Msg alert tone
>
p
q
MSG ALERT TONE
>On
p
q