Table of Contents
Advertisement
Hardware Installation
Lock up (freeze)
When I boot up my system, everything works fine. It sees my CPU and
memory, detects my hard drive, floppy drive and CD-ROM but locks
up at "Verify DMI pool data... ", and it won't go any further. What
should I do?
Please clear the CMOS via JP5 then choose 'load optimized default' in the
bios and save the bios and exit. Next, unplug all other add-on cards except
the video card and floppy drive controller, and see if it can boot from
floppy. Then put back the peripherals one by one to identify which one
causes the lockup.
I can not get my board to run properly.
Please make sure you have the latest bios and driver from the SOYO web
site at:
http://www.soyo.com
I can not use my SCSI card on PCI slot#2, what's the problem?
Move the SCSI card to another PCI slot, PCI slot#2 and the on-board
RAID share the same INT, or disable the on-board RAID.
RAID Issues
I can not use RAID function on IDE 3_4.
Please check RAID_IDE jumper setting on page 43.
2-3.9 Power Off
There are two possible ways to turn off the system:
1.
Use the Shutdown command in the Start Menu of Windows 95/98
to turn off your computer.
2.
Press the mechanical power-button and hold down for over 4
seconds, to shutdown the computer. If you press the power-button for
less than 4 seconds, then your system will enter into Suspend Mode.
You are now ready to configure your system with the BIOS setup program.
Go to Chapter 3: BIOS SETUP
SY-K7V DRAGON
50
Advertisement
Table of Contents
