Table of Contents
Advertisement
Confirming Driver Installation in Windows 98/95
To confirm that the driver has been properly loaded in Win 95/98, perform the
following steps:
1.
Choose "Settings" from the "Start" menu.
2.
Choose "Control Panel," and then double-click on the "System" icon.
3.
Choose the "Device Manager" tab, and then click the "+" in front of "SCSI &
RAID controllers." "Win95-98 Promise FastTrak100-Lite controller" should
appear
WINDOWS NT4
Installing Drivers During Windows NT 4.0 Installation
1.
Start the system installation by booting from the Windows NT disk:
a)
Floppy install: boot the system with the Windows NT installa-
tion diskettes.
b)
Floppyless install: boot from floppy and type "WINNT /B".
After files have been copied, the system will reboot. On the
reboot, press the "F6" key when the message "Setup is inspect-
ing your computer's hardware configuration..." appears.
c)
CD-ROM disk install: boot from the CD-ROM disk and press
the "F6" key when the message "Setup is inspecting your com-
puter's hardware configuration..." appears.
2.
When the "Windows NT Setup" window is generated, press "S" to
Specify an Additional Device(s).
3.
Press "O" to select "Other" and press the "Enter" key.
4.
Insert the diskette* into drive A: and press the "Enter" key.
5.
Choose "Win NT FastTrak100-Lite (tm) Controller" from the list that
appears on screen, then press the "Enter" key.
139
Advertisement
Table of Contents
