Table of Contents
Advertisement
(recommended), or you can create a Security array using an existing hard drive
and a new hard drive.
1.
Boot your system. If this is the first time you have booted with the
FastTrak100-Lite and drives installed, the Promise onboard BIOS will display
the following screen.
FastTrak100-Lite (tm) BIOS Version 1.xx (Build xxxx)
(c) 1995-2000 Promise Technology, Inc. All Rights Reserved.
No array defined . . .
Press <Ctrl-F> to enter FastBuild (tm) Utility
Or press <ESC> key to continue booting the system.
2.
Press <Ctrl-F> keys to display the FastBuild (tm) Utility Main Menu
3.
Press "1" to display the Auto Setup Menu below. This is the fastest and easiest
method to creating your first array.
FastBuild (tm) Utility 1.xx (c) 1995-2000 Promise Technology, Inc.
Optimize Array for:
Typical Application usage:
Mode ..........................................Stripe
Drives used in Array..........................2
Array Disk Capacity................... 16126
[↑] Up [↓] Down
WARNING: If creating a Security array using an existing hard
drive, backup any necessary data. Failure to follow this accepted
PC practice could result in data loss.
[Auto Setup Options Menu]
[ Auto Setup Configuration ]
[ Keys Available ]
[←, →, Space] Change Option
Performance
A/V Editing
114
[ESC] Exit
[Ctrl-Y] Save
Advertisement
Table of Contents
