Disassembly/Reassembly Of The Upper Part Of The Mechanism - Olivetti XZAC4219-03 PR2 plus Service Manual

DISASSEMBLY/REASSEMBLY OF THE UPPER PART OF THE MECHANISM

9.2.8
• Remove the casing as explained above
• From the front, lift the entire mechanism from the baseplate and rotate it partially so as to access the
connectors of the motherboard.
• Disconnect the connection cables of the printhead and of the carriage reset photosensor from the
motherboard. Free the wire of the carriage reset photosensor from the plastic clips.
• Disconnect the connector (1) from the carriage transport motor.
• Lift the upper part of the mechanism using the specific levers.
• Back off the two rear side hinge pins (2) to disconnect the upper part of the mechanism.
Note: During reassembly, make sure that the cables are passed through the related compartments and check
adjustment of the roller gear (par. 8.8).
XZAC4219-03
2
Figure 9-14
Service Manual
1
9-15