Table of Contents
Advertisement
8.13 POSITIONING OF HORIZONTAL MAGNETIC/MICR PRESSURE ROLLER
MACHINE STATUS:
Pin of the bridge (4) on its minimum radius.
With regard to the above, position the pressure roller (1) inside the conveyor (2) with a recess of 0.5-1 mm
and, then phase the cam (3) so as to bring the pin of the bridge (4) on its minimum radius. With its screw (5)
fasten the bridge on the shaft (check that the recess of the pressure roller is across the entire paper path).
CONDITIONS TO BE CHECKED:
Pressure roller in work position.
PROCEDURE:
Rotate the cam so as to bring the pin of the bridge (4) on its maximum radius; then check that with the
pressure roller resting on the paper sliding surface, there is play in the coupling of point "A".
3
4
5
A
2
1
0,5-
Figure 8-13
8-14
XZAC4219-03
Advertisement
Table of Contents
