Table of Contents
Advertisement
CHECK ON OPENING OF FRONT BAND
8.7
MACHINE STATUS:
Rear structure closed and carriage completely to the right.
CONDITIONS TO BE CHECKED:
Distance between the front band and print bar.
PROCEDURE:
After checking correct adjustment of the band (as indicated in the paragraph above), close the rear structure
and move the carriage to the right. Using a probe, check that the point of the band is positioned at a distance
of between 8 and 11 mm from the print bar, measuring this at 5 - 6 cm from the left-hand edge of the print
carriage.
8 - 11 mm
Figure 8-7
8-8
XZAC4219-03
Advertisement
Table of Contents
