Table of Contents
Advertisement
MANUAL PROCEDURE
This type of cleaning is carried out by the service engineer outside the scheduled operations established by
the automated procedure.
A read magnetic stripe system command must be invoked also in this case.
Insert the cleaning card facing in the right direction inside the feed slot; the machine will perform a read
attempt and, at the end of this, will eject the card and indicate an error.
To restore normal operating conditions, switch the printer off and on again.
Cleaning stripe side
Back
Figure 7-1 Magnetic head cleaning card
7.2 MAINTENANCE
A brush installed in the right-hand inner part of the mechanism cleans the paper edge detection photosensor,
located close to the printhead. Brush life is the same as that of the printer. Exceptionally, if dust accumulates
on the paper photosensor in the meantime, it is advisable to replace the brush.
7-2
XZAC4219-03
Advertisement
Table of Contents
