NETGEAR FVS336Gv3 Reference Manual page 58

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
Your settings are saved.
Configure the Failure Detection Method for IPv4 WAN Interfaces
The following procedure describes how to configure the failure detection method for IPv4
WAN interfaces that function in auto-rollover mode.

To configure the failure detection method for IPv4 WAN interfaces:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Network Configuration > WAN Settings > WAN Setup.
The WAN Setup screen displays the IPv4 settings.
7. In the WAN IPv4 Settings table, click the Edit button for the WAN interface that you
selected as the primary WAN interface.
The WAN IPv4 ISP Settings screen displays.
8. Click the Advanced option arrow in the upper right.
The WAN Advanced Options screen displays for the WAN interface that you selected.
9. Locate the Failure Detection Method section.
10. Enter the settings as described in the following table.
Configure the IPv4 Internet and WAN Settings
58