NETGEAR FVS336Gv3 Reference Manual page 422

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
7. Enter the settings as described in the following table.
Setting
PPTP Server
Enable
Start IP Address
End IP Address
User time out
Authentication
Select one or more of the following authentication methods to authenticate PPTP users:
• PAP. RADIUS-Password Authentication Protocol (PAP).
• CHAP. RADIUS-Challenge Handshake Authentication Protocol (CHAP).
• MSCHAP. RADIUS-Microsoft CHAP (MSCHAP).
• MSCHAPv2. RADIUS-Microsoft CHAP version 2 (MSCHAPv2).
Encryption
If the authentication is MSCHAP or MSCHAPv2, the PPTP server can support Microsoft Point-to-Point
Encryption (MPPE). Select one or more of the following types of MPPE:
• MPPE-40. MPPE 40-bit encryption.
• MPPE-128. MPPE 128-bit encryption. This is the most secure type of MPPE encryption.
• MPPE-stateful. Stateful MPPE encryption. This is the least secure type of MPPE encryption.
8. Click the Apply button.
Set Up Virtual Private Networking With IPSec Connections
Description
To enable the PPTP server, select the Enable check box.
Type the first IP address of the address pool.
Type the last IP address of the address pool. A maximum of 26 contiguous
addresses can be part of the pool. (The first address of the pool cannot be
assigned to a user.)
Enter the time-out period in seconds, from 0 to 999 seconds. The default is
0 seconds. If there is no traffic from a user, the connection is disconnected after
the specified period.
422