NETGEAR FVS336Gv3 Reference Manual page 469

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
7. In the upper right, select the IPv6 radio button.
The SSL VPN Client screen displays the IPv6 settings. The following figure shows
examples.
8. In the Add Routes for VPN Tunnel Clients section, complete the following fields:
• Destination Network. The IPv6 address of the local destination network that
provides access to one or more port forwarding applications and services.
• Prefix Length. The prefix length for the local destination network.
9. Click the Add button.
The new client route is added to the Configured Client Routes table.
Note: If VPN tunnel clients are already connected, you can disconnect the
clients (see
Disconnect Active Users
addresses and routes when they reconnect.
Remove an IPv4 or IPv6 Client Route
The following procedure describes how to remove a client route that you no longer need.

To remove an IPv4 or IPv6 client route:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
View the VPN Firewall SSL VPN Connection Status and
on page 447) to allow them to receive new
Set Up Virtual Private Networking with SSL Connections
469