NETGEAR FVS336Gv3 Reference Manual page 33

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
Note: If your ISP requires MAC authentication and another MAC address was
previously registered with your ISP, you must configure that MAC address
on the VPN firewall (see
Firewall

To automatically configure a WAN port for an IPv4 Internet connection:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Network Configuration > WAN Settings > WAN Setup.
The WAN Setup screen displays the IPv4 settings.
The IPv4 WAN Settings table displays the following fields:
• WAN. The WAN interface (WAN1 or WAN2).
• Status. The status of the WAN interface (UP or DOWN).
• WAN IP. The IPv4 address of the WAN interface.
Change the Advertised MAC Address of the VPN
on page 70) before you begin the following procedure.
Configure the IPv4 Internet and WAN Settings
33