Stage 5; Testing The System - Extron electronics VoiceLift Installation Manual

Stage 5:

Testing the System

This stage consists of configuring, setting up, and testing the VoiceLift System.
1. Set up the microphones.
Set up each microphone in your VoiceLift system
as follows:
a.
Set the channels using the rotary switch. A
and C are at 2.3 MHz, and B and D are at
2.8 MHz.
NOTES:
• Each microphone must be set to a
different frequency; in other words,
only channels A and B, A and D,
B and C, or C and D can be used
together (on the VLH 102 Handheld
Microphone you can select only
channels A and B).
• If the student is using a pendant
microphone, it is recommended
that you disable the volume buttons
by setting the channel to C or D.
This prevents the student from
inadvertently pressing both volume
buttons simultaneously and sending
an instant alert (see
Example — Setting Up an Instant
Alert beginning on page 37).
b.
(Pendant microphone only) Apply a Teacher,
Student, Mic 1, or Mic 2 label to the back of
the microphone.
c.
Remove the battery cover and insert the
battery.
d. Replace the battery cover.
Installation
VoiceLift System with PVS 405D Installation Guide • Installation — Stage 5
A B
C
D
Î Î
VLP 202 Pendant Microphone
A B
Î Î
A B
VOLUME
VLH 102 Handheld Microphone
– Set up the microphone.
Î Ð
33