Stage 1: Mounting The Receiver; Receiver Housing And Back Plate; Z Bracket And Mounting Screw (For Installation On A Drop Ceiling) - Extron electronics VoiceLift User Manual

Stage 1:
Mounting the
Receiver
Stage 1 consists of installing the pieces of hardware shown below and on the next
page.

Receiver Housing and Back Plate

Conduit Knockouts (2)
Where it goes:
What it does:

Z Bracket and Mounting Screw (for Installation on a Drop Ceiling)

Where it goes:
What it does:
Back Plate
Raceway Knockouts (2)
Receiver
Housing
The housing attaches to the receiver dome, and the back plate
mounts to a ceiling tile or a wall.
Protects the receiver base plate and connectors. The housing
contains knockouts for different sizes of raceways, and the back
plate contains knockouts for a conduit.
Z-bracket
Mounting Screw
The mounting screw passes through the receiver back plate, then
through the hole in the ceiling tile. The bracket is attached to
the screw on the back of the ceiling tile.
Fastens the receiver to a tile in a drop ceiling.
VoiceLift Microphone Systems • Installation — Stage 1 17