Stage 1C - Installing The Receiver On A Wall Or Other Hard Surface - Extron electronics VoiceLift Installation Manual

Stage 1c — Installing the Receiver on a Wall or Other Hard Surface
1. Install a raceway if needed.
If using a raceway for the cables, install it at the
appropriate location on the mounting surface.
NOTE: Raceway knockouts on the receiver
housing fit common types of raceways
such as the Wiremold 500/700 series
and the Wiremold 2400 series. Follow the
instructions provided by the manufacturer
to install the raceway.
2. Mark the mounting screw locations on the
surface.
Use the screw holes in the receiver housing
as guides to mark the screw locations on the
mounting surface.
3. If using a raceway, remove the appropriate
knockout in the receiver housing.
a. Use a knife to score around the edge of the
selected raceway knockout to create a clean
edge.
b. Press on the scored section to remove it.
VoiceLift System with PVS 405D Installation Guide • Installation — Stage 1
Install the raceway (if needed).
1
Mark mounting screw locations in the
2
surface.
Remove a raceway knockout from the
3
housing, if needed.
Raceway
Knockouts (2)
19