Extron electronics VoiceLift Installation Manual page 40

1. Set up the microphones (continued).
e. Attach the lanyard to the VLP 202 (pendant
microphone only).
i.
Press the lanyard into the guides on either
side of the lanyard clip.
Guides on Lanyard Lock
Top View
ii. Press the top of the microphone rear clip
to raise it.
iii. Slide the lanyard lock under the clip and
release the clip.
f. Charge the microphone for 5 hours.
2. Set the microphone gain and feedback
suppressor (FBS).
The VoiceLift feedback suppressor eliminates
feedback from the microphone. Follow these
steps to achieve the best performance from the
FBS:
a.
Power on the VoiceLift system. The Power
LEDs on the microphone and receiver should
light green.
If the microphone has been in operation, cycle
power on the receiver to clear any existing
filters.
34 VoiceLift System with PVS 405D Installation Guide • Installation — Stage 5
Press lanyard into guides.
Clip
Lock
Attach the lanyard to the pendant
Ò
microphone.
Power LED
Power Switch
Power on the microphone.
Õ
Power LED
Power Switch