Stage 1C - Installing The Receiver On A Wall Or Other Hard Surface - Extron electronics VoiceLift User Manual

Hide thumbs Also See for VoiceLift:

Table of Contents

Stage 1c — Installing the Receiver on a Wall or Other Hard Surface

1. Install a raceway if needed.

If using a raceway for the cables, install it at the

appropriate location on the mounting surface.

Raceway knockouts on the

NOTE:

receiver housing fit common

types of raceways such as the

Wiremold 500/700 series and the

Wiremold 2400 series.

2. Mark the mounting screw locations on the

surface.

Use the screw holes in the receiver housing

as guides to mark the screw locations on the

mounting surface.

3. If using a raceway, remove the appropriate

knockout in the receiver housing.

Use a knife to score around the edge of the

selected raceway knockout to create a clean

edge.

Press on the scored section to remove it.

Install the raceway (if needed).

Mark mounting screw locations in the

surface.

Remove a raceway knockout from the

housing, if needed.

VoiceLift Microphone Systems • Installation — Stage 1

Raceway

Knockouts (2)

Table of Contents