System Settings - Fuji Xerox DocuPrint C2090 FS User Manual

1.
Press the <Menu> button on the control panel. Use the <▼> buttons to select [Configuration Need
Password] and press <Set>.
2.
Use the <◄/►> buttons to select [Network Config - Network] and press <Set>.
3.
Use the <◄/►> buttons to select [Network Config - TCP/IP] and press <Set>.
4.
Use the <◄/►> buttons to select [IP Address], [Subnet Mask], or [Gateway address].
5.
Press <Set> to confirm.
To specify the protocol setting, do the following:
1.
Press the <Menu> button on the control panel. Use the <▼> buttons to select [Configuration Need
Password] and press <Set>.
2.
Use the <◄/►> buttons to select [Network Config - Network] and press <Set>.
3.
Use the <◄/►> buttons to select [Network Config - Protocol] and press <Set>.
4.
Use the <◄/►> buttons to select [LPD] or [Port 9100] and press <Set>.
5.
Use the <◄/►> buttons to turn the option ON/OFF.
6.
Press <Set> to confirm.
To specify the IP Filter setting, do the following:
1.
Press the <Menu> button on the control panel. Use the <▼> buttons to select [Configuration Need
Password] and press <Set>.
2.
Use the <◄/►> buttons to select [Network Config - IP Filter1] and press <Set>.
3.
Use the <◄/►> buttons to select [IP Filter1], [IP Filter1-Subnet Mask], or [IP Filter1- Filter Mode
(OFF/Deny/Allow)], and press <Set>.
4.
Press <Set> to confirm.

8.7 System settings

You can specify system settings for Power Save mode, Power Save Timer, Warning Beep, Menu Time Out,
or Time & date under the system settings submenu.
To enable the Power Save mode, do the following:
1.
Press the <Menu> button on the control panel. Use the <▼> buttons to select [Configuration Need
Password] and press <Set>.
2.
Use the <◄/►> buttons to select [Configuration - System] and press <Set>.
3.
Use the <◄/►> buttons to select [Power Save mode] and press <Set>.
4.
Use the <◄/►> buttons to turn the Power Save mode ON/OFF.
5.
Press <Set> to confirm your setting.
To specify the Power Time Saver setting, do the following:
- 79 -