Scanning; Placing The Originals; Scanning An Image With Operating Panel; Setting Scan Mode From Control Panel - Fuji Xerox DocuPrint C2090 FS User Manual

5. Scanning

This chapter helps you to scan documents and save the scanned copy on your computer using the software
CD provided in the package.

5.1 Placing the originals

Before scanning, make sure the transportation lock on the back of the part B is set to the unlock position.
Always keep the document glass clean to prevent dirty or blurry images.
Note:
• If you place originals on both Auto Document Feeder (ADF) and the document glass, only the
documents in the ADF are scanned. And you will hear a beep sound and a warning message appears
to remind you to remove the document on the document glass.

5.2 Scanning an image with operating panel

There are two ways to scan an image using the DocuPrint C2090 FS. You can either perform scanning task
directly through the control panel on the DocuPrint C2090 FS, or use any image editing software that is
TWAIN compatible, such as Fuji Xerox DocuWorks Desk software provided in the CD Rom. Before scanning
to PC, make sure that the cable is connected and software is success installed on your computer.
5.2.1

Setting scan mode from control panel

To choose the destination for scanned documents or images, do the following:
- 47 -