Garmin G3X Installation Manual page 99

7.4.10 LOG Configuration Page
The Data Logging Configuration page enables the storage of flight data as .csv files to the "data_log"
folder on an SD card. If data logging is enabled, the files are automatically written to the SD card after it
is inserted into the card slot. These files can be opened in Excel, or imported into Google Earth for
viewing using the Garmin Flight Log Conversion tool. The tool and instructions needed to import the
files into Google Earth are available from the G3X Product Page found on the Garmin website
www.garmin.com.
Select On or Off for SD Card Data Logging and set the maximum number of log files to be stored.
7.4.11 ENG Configuration Page
The Engine/Airframe Input Configuration section of the Engine Configuration Page allows
enabling/disabling and customization of the engine/airframe input options that make up the EIS display
and the Engine Page on the MFD. Refer to Section 8 Engine/Airframe Sensor Installation and
Configuration, for configuring items listed in the Engine/Airframe Input Configuration section of the
Engine Configuration page.
7.4.11.1 Configuration Sync Status
The Configuration Sync Status items appear at the bottom of the Engine Configuration Page. A green
checked box indicates a GDU or GSU that is communicating with PFD1, and that "agrees" with PFD1's
engine configuration . A red X in the config sync status box indicates a GDU that is connected but has
different data from PFD1. After a few seconds it should change back to a green checkmark as the units
get back in sync. Units that are not connected are shown in subdued (gray) text.
G3X Installation Manual – Software, Configuration, Databases, and XM Activation Page 7-19
190-01115-01 Revision E