Garmin G3X Installation Manual page 124

For factory-installed systems, the Engine/Airframe Input Configuration section is replaced with an EIS
Configuration page that allows access to calibration functions and time adjustments, but does not allow
changing EIS configuration values. See Section 8.3.3 for calibration information, and Section 8.3.2 for
Engine Time and Total Time information.
Refer to Sections 7.3 and 7.4 for configuration mode instructions, then follow the below steps to make
changes to the Engine/Airframe Input Configuration.
1. In configuration mode, use the FMS Joystick to select the Engine/Airframe Input
Configuration Page.
2. Use the FMS Joystick to select the desired configurable item and make the desired change(s)
(Sections 8.3.1 – 8.3.3).
3. Press the Save softkey to store settings or press the Cancel softkey to cancel changes and
return to the Engine Configuration Page.
4. Press the FMS Joystick to move the cursor to the page selection menu when finished.
Page 8-20
Revision E
G3X Installation Manual – Engine Sensor Installation and Configuration
190-01115-01