Garmin G3X Installation Manual page 150

9. Verify that the 3 on-screen statements are true. If either tilt angle is greater than 3.0 degrees,
"Out of spec" is displayed.
To accommodate multiple mounting orientations, the reported tilt angles are displayed as
"X and Y" instead of "Pitch and Roll".
10. After verifying the statements 1-3 are true, select OK to store the cal values. Ensure that a
CALIBRATION SUCCESSFUL message appears at the bottom of the display, press the ENT
Key to return to the GSU Status Page.
The magnetometer calibration (Calibration Procedure D) must be completed after each pitch/roll offset
calibration.
Page 9-10
Revision E
NOTE
G3X Installation Manual – Post Installation Checkout and Calibration Procedures
190-01115-01