Programming Multiple Units Overview 2 111 - Chamberlain Elite EL Series Programming Manual

Programming Multiple Units Overview
Up to seven (7) units can be installed on a single telephone line. Each
unit must have a "Unique Unit ID" number and the "Number of Units in
Chain" assigned to it.
Set the Unit ID Number and Number of Units in Chain:
The unit ID identifies each unit within a chain. Adding or removing will require the unit ID's to be
Factory Setting: Unit ID 1 and Number of Units in Chain 1.
re-entered.
1 Press Then
Unit ID Number (1-7), Then
2
Total Number of Units in Chain (1-7), Then
3
Example:
Unit ID "1"
Residence
Important:
You must program each unit ID using the main keypad first before attempting remote access.
EACH unit in the Chain must have the same "Rings Before Answer"
Factory Setting - 5 Rings
EACH unit in the Chain must have the same "Alternate Prefix"
Factory Setting - Normal (use
Be sure to set the rings before answer value
aborting attempt 14
Verify Unit Number:
This allows you to verify a unit's number within a chain. When you perform this step, the unit will
respond with the number corresponding to its unit ID number. The message two (2), for
example, means the unit is number 2 in the chain.
If you make an error during an entry, press the asterisk key (*) to begin again.
Unique Unit ID Sequencial Order
Unit ID "2"
U G 1 0 , 2 0 0 5
U G 1 0 , 2 0 0 5
W E L C O M E W E L C O M E
Number of Units in Chain "7"
16
.
111
Then
Page 20
2
Important: This must be performed
for EACH unit in the Chain
Unit ID "3"
Unit ID "7"
U G 1 0 , 2 0 0 5 U G 1 0 , 2 0 0 5
W E L C O M E W E L C O M E
16 .
115 .
to enter programming)
is greater than maximum rings before
Telco Entrance Box
Demarcation Point