Speaker-Microphone Settings; Enable Or Disable Call Waiting - Chamberlain Elite EL Series Programming Manual

Set a Phone Number's Extension Delay Time:
When the unit is programmed to dial a resident with a phone number and extension, and
needs to be entered a short time after the automated phone system's greeting message has
finished, the unit allows a delay time, between the phone number and the extension number
or call forward extension number.
Press
1
Enter Directory Code (Up to 2 Digits). Then (#)
2
Enter Phone Extension Delay (0-30 seconds). Then (#)
3
Enter Call Forward Extension Delay (0-30 seconds). Then (#)
4
Example:
Gives Directory Code "7" a 10 second Delay between its phone number and extension number.
Set Speaker Volume:
Allows the visitor to hear the resident at the unit.
Press Then
1
Enter Speaker Level (0=Mute, 1=Low through 10=Highest). Then (#)
2
Enter Voice Audio Level (0=Mute, 1=Low through 3=Highest). Then (#)
3
Enter Beep Audio Level (0=Mute, 1=Low through 3=Highest). Then (#)
4
Set Microphone Volume:
Allows the resident to hear the visitor at the unit.
Press Then
1
Enter Microphone Level (0=Mute, 1=Low through 10=Highest). Then (#)
2
If you're on your phone and a visitor attempts to contact you from the unit, you will hear 2
short tones in your phone. You can press "2" on your phone to toggle between the phone
call and the visitor. This feature only works for a single-family residence or a manager's
phone sharing a phone line with the unit.
Press Then
1
Enable (1) or Disable (0). Then (#)
2
If you make an error during an entry, press the asterisk key (*) to begin again.
Factory Setting: No Delays
Then
1
Speaker / Microphone Settings
18
19

Enable or Disable Call Waiting

Factory Setting: Enabled
Page 59
110
4
2 3
Factory Setting: 5, 2, 2
NOTE: The visitor can
adjust the speaker
volume on unit with this
key. Unit will return to
programmed volume
setting when call is
complete.
Factory Setting: 5
Example:
1
Disables the call waiting.
9
2