Resident - System Programming Using The House Phone; Resident - Direct Commands Using The House Telephone; Resident - Direct Commands Using A Forwarded Telephone - Chamberlain EL1SS Resident Manual

RESIDENT - SYSTEM PROGRAMMING USING THE HOUSE PHONE

PROGRAM DESCRIPTION
NUMBER
**01 ENABLE CALL FORWARDING
Factory Setting: Disabled NOTE: This setting requires the system to
be connected to the residence's phone line and Telco Mode to be
enabled (see Installation and Set Up Manual).
**02 DISABLE CALL FORWARDING
**03 ENABLE INTERCOM MODE Factory Setting: Disabled
**06 VERIFY CALL FORWARDING NUMBER (VIA CALLER ID)
Factory Setting: Disabled
**07
ENABLE TELCO MODE Factory Setting: Enabled
**#8 ERASE CALL FORWARDING NUMBER
NOTE: This command will also disable the call forwarding mode.
**10 ADJUST "PICK UP" RING COUNT Factory Setting: 5
**13 ENABLE ALTERNATE DTMF PROGRAMMING
This feature changes the leading programming digits from ** to ##
(and *# to #*) to work around phone lines (or telephone equipment)
that reacts to the * tone. Factory Setting: Disabled
**14 ENABLE STANDARD (LONG) RING TONE Factory Setting: Enabled
**15 ENABLE ALTERNATE (DUAL) RING TONE
Factory Setting: Enabled NOTE: Alternate ring tone function may not
work with all phones
#*16 DISABLE ALTERNATE DTMF PROGRAMMING
*# Call ENTER CALL FORWARDING TELEPHONE NUMBER
Forwarding
Number #

RESIDENT - DIRECT COMMANDS USING THE HOUSE TELEPHONE

PROGRAM DESCRIPTION
NUMBER
**04 ENABLE PARTY (LATCHED) MODE - RELAY 1
Party Mode will latch the relay and keep the entry device open to allow guests
access to property. To disengage party mode: Enter "*9" into the local telephone.
**05 DISABLE PARTY (LATCHED) MODE - RELAY 1
To disengage party mode: Enter "*9" into the local telephone.
*5 ACTIVATES RELAY 2
*9 ACTIVATES RELAY 1
**11 ENABLE "DO NOT DISTURB" MODE
This mode disables calls from the system to the house or forwarded telephone.
Factory Setting: Disabled
**12 DISABLE "DO NOT DISTURB" MODE

RESIDENT - DIRECT COMMANDS USING A FORWARDED TELEPHONE

PROGRAM DESCRIPTION
NUMBER
0
By entering
with the visitor (also extends talk time).
*5 ACTIVATES RELAY 2
*9 ACTIVATES RELAY 1
CALL WAITING
Press "Flash" once to answer guest, press again to return to outside call on telco
line, if *9
EL1SS will automatically return to the telco line.
0 the audio is initiated for the resident to have a phone conversation
or *5 is not pressed. If *9 (relay 1) or *5 (relay 2) is pressed, the
3
TO PROGRAM
**01
**02
**03
**06 Hang up the phone - Wait
for the ring.
**07
**#8
**10 + Ring Count 2 through
**13
NOTE: The telephone line
should be disconnected while
entering this command.
**14
**15
#*16
*# + Telephone Number
14 digits) + #
TO PROGRAM
**04
**05
*5
*9
**11
**12
TO PROGRAM
0
*5
*9
5
(Up to