Activate Or Deactivate A Transmitter; Verify A Transmitter - Chamberlain Elite EL Series Programming Manual

Activate or deactivate a transmitter on a specific date and time.
Activate / Deactivate a Transmitter:
Disabling the Activate Transmitter
the four If statements could apply:
1. If you disable the Start Activation Date
Transmitter will immediately become active and stay that way until the code is deactivated or deleted.
2. If you enable the Start Activation Date
Date 9 , the Transmitter will activate on that "Start Date and Time".
3. If you disable the Start Activation Date
9A 9B , the Transmitter will deactivate on that "End Date and Time".
4. If you enable the Start Activation Date
and add an "End Date and Time"
the "End Date and Time".
To Activate or Deactivate a Transmitter:
Press Then
1
Enter Transmitter Number (1-65534). Then (#)
2
Enter Facility Code (0-255). Then (#)
3
Enter Sequence Code (0-2). Then (#)
4
Enter ID Number (0-26). Then (#)
5
Enter Button Number (1-4). Then (#)
6
Activate Transmitter (Enable-1 or Disable-0). Then (#)
7
NOTE: All time must be entered using a 24-hour format (8AM=0800, 3PM=1500 etc.)
Example:
1 2
Activates transmitter number "34432", facility code "25", sequence code "1", ID code "10", and button "1" activated
on February 1st, 2004 at 6PM.
Audio Feedback "Invalid Step": Indicates the transmitter code Does Not exist in the database.
Audio Feedback "Valid Step": Indicates the transmitter code Does exist in the database.
Press Then
1
Enter Transmitter PIN Code (1-65534). Then (#)
2
Enter Facility Code (0-255). Then (#)
3
Example:
1
Transmitter with PIN code "43323", facility code "1", sequence code "1", ID code "25", and button "1"
activated is NOT valid.

Activate or Deactivate a Transmitter

7 , the Card will always be deactivated. If you enable the Activate Transmitter
8 and disable the End Deactivation Date
8 and add only a "Start Date and Time"
8 and enable the End Deactivation Date
8 and add a "Start Date and Time"
9A 9B , the Transmitter will activate on that "Start Date and Time" and deactivate on
3 4 5 6

Verify a Transmitter

2 3
Page 48
9 and omit all dates and times, the
8A 8B and disable the End Deactivation
9 and add only an "End Date and Time"
8A 8B enable the End Deactivation Date
Use Start Activation Date, (Enable-1 or
8
Disable-0). Then (#)
Start Date (yymmdd). Then (#)
8A
Start Time (hhmm). Then (#)
8B
Use End Deactivation Date, (Enable-1 or
9
Disable-0). Then (#)
End Date (yymmdd). Then (#)
9A
End Time (hhmm). Then (#)
9B
Year Month Day
7 8 8A
Enter Sequence Code (0-2). Then (#)
4
Enter ID Number (0-26). Then (#)
5
Enter Button Number (1-4). Then (#)
6
4 5 6
98
7 , then
9
24-Hour Time
8B 9 9B 9B
96
Then System Beeps ONCE