Winding The Bobbin - Janome Decor Excel II 5024 Instruction Manual

Janome 5024 Instruction Manual
7
www.aaasewing.com
10
¥ Winding the Bobbin
Lift up the spool pin. Place the spool of thread
on the spool pin with the thread coming off
the spool as shown.
Attach the large spool holder, and press it
firmly against the spool of thread.
* The small spool holder is used with narrow
or small spools of thread.
* To use the additional spool pin, guide the
upper thread as shown in
Guide the thread around the thread guide.
Pass the thread through the thread guide.
Thread through the hole in the bobbin from
the inside to outside. Put the bobbin on the
bobbin winder spindle.
Push the bobbin to the right.
A red light on the front panel will come on.
With the free end of the thread held in your
hand, depress the foot control. Stop the
machine when it has made a few turns, and
cut the thread close to the hole in the
bobbin.
Depress the foot control again. When the
7
bobbin is fully wound, it will stop automatically.
Return the bobbin winder to its original
position by moving the spindle to the left, and
cut the thread as shown.
* The machine will not sew until the spindle is
in the left position.
Spool pin
Spool
Spool holder
Additional spool pin
Felt
Additional spool pin hole
Bobbin winder spindle
.
,
5024 Owners Manual/ User Guide