Table of Contents
Advertisement
w
e
q
w
e
r
e
t
Winding the Bobbin
q
Removing the Bobbin
Slide the hook cover release button to the right, and
remove the hook cover plate.
q Hook cover release button
w Hook cover plate
Lift out the bobbin from the bobbin holder.
e Bobbin
NOTE:
Use the J plastic bobbins for horizontal hook (marked
with "J" r). Using other bobbins, such as pre-wound
paper bobbins, may cause stitching problems and/ or
damage to the bobbin holder.
r
Setting the spool of thread
Lift up the spool pin. Place the spool of thread on the
spool pin with the thread coming off the spool as shown.
Attach the large spool holder, and press it firmly against
the spool of thread.
q Large spool holder
NOTE:
Use the small spool holder to hold narrow or small
spools of thread.
Spool Holder (special)
Use the spool holder (special) when using a long spool of
thread as shown.
e 9.5 - 10.5 mm (3/8 - 7/16˝)
r 70 - 75 mm (2-3/4 - 3˝)
y
Attach the spool holder (special) by inserting it into the
hole of the spool of thread. Make sure there is no gap
between the spool holder and the spool of thread.
t Spool holder (special)
y No gap
Extra spool pin
Use the extra spool pin when you need to wind a bobbin
without unthreading the machine while working on a
sewing project.
Insert the extra spool pin into the spool supporter and
r
then into the hole beside the horizontal spool pin.
Place the felt cushion on the spool pin and place a spool
q
of thread on it as shown.
q Extra spool pin
w
w Spool supporter
e Hole for extra spool pin
e
r Felt cushion
NOTE:
The extra spool pin is also used for twin needle
sewing.
18
w Small spool holder
Advertisement
Table of Contents
