Automatic Buttonhole - Janome Decor Excel II 5024 Instruction Manual

Janome 5024 Instruction Manual
www.aaasewing.com
0 1 2 3 4 5 6
0 1 2 3 4
3
2
4

Automatic Buttonhole

Stitch selector:
Stitch width:
Stitch length:
Top thread tension:
Presser foot:
* The size of buttonhole is automatically set by
placing the button in the automatic
buttonhole foot (R).
* The button holder of the foot takes a button
size up to 2.5 cm (1Ó) in diameter.
* Make a test buttonhole on a sample
duplicating the fabric, interfacing and seams
of the actual garment.
* Place the button on the fabric sample and
mark the top and bottom to determine the
position of buttonhole.
* Use interfacing on the stretch fabrics.
Attach the automatic buttonhole foot R.
Make sure the groove on the holder catches
the pin on the foot when lowering the presser
foot.
Groove
Pin
Pull the button holder to the back, and place
the button in it. Push it together tightly on the
button.
Button holder
If the button is extremely thick, make a test
buttonhole.
If it is difficult to fit the button through the test
buttonhole, lengthen by pulling the button
holder on the foot back to increase length.
Gap
c Pull the buttonhole lever downward as far as it
will go.
Butonhole lever
BH
4Ð6.5
1Ð5
R: Automatic button hole foot
5024 Owners Manual/ User Guide
23