Janome Decor Excel II 5024 Instruction Manual page 26

Janome 5024 Instruction Manual
7
8
www.aaasewing.com
24
ÒAÓ
ÒBÓ
Draw both threads to the left under the foot.
Insert the garment under the foot, and lower
the needle at the starting point.
Then lower the automatic buttonhole foot.
* Make sure there is no gap
slider and the spring holder
If there is a gap
will be different, as shown in
Mark for placement of buttonhole
Starting point
Slider
There should be no gap.
Spring holder
Difference
Depress the foot control until the machine
stops by itself.
* When a buttonhole is completed, the BH
indicator light will flash.
* The buttonhole will be automatically sewn:
The front bartack and left row first, then the
back bartack and right row.
The machine will stop automatically.
Cut both needle and bobbin threads
leaving about 10 cm (4Ó) thread ends.
Draw the needle thread to the wrong side of
the fabric by pulling the bobbin thread.
Then, knot the threads.
Insert a pin inside the bartack.
7
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
(To sew a series of same-size buttonholes)
8 To reset the buttonhole sewing function,
select a different stitch pattern with the
pattern selector dial (A), then return it to the
buttonhole.
Pattern selector dial
between the
.
, the length of the rows
.
5024 Owners Manual/ User Guide