Stove Installation; Installation Preparation; Items Packed With The Heater; Additional Items Required For Stove Install - Lopi Spirit B-Vent Gas Stove Owner's Manual

S
TOVE
P 6
AGE

Installation Preparation

! This appliance must be installed in accordance with all local codes, if any; if not, follow ANSI
Z223.1 and the requirements listed in this manual. Failure to follow all of the requirements
may result in property damage, bodily injury, or even death.
! Notify your insurance company before hooking up this heater.
! The requirements listed below are divided into sections. All requirements must be met
simultaneously. The order of installation is not rigid Ð the qualified installer should follow the
procedure best suited for the installation.

Items Packed with the Heater

¥ Lopi Spirit Gas Heater
¥ Log Set (2 Logs, 2 Twigs, Coals)
¥ Owner's Manual
Additional Items Required for Stove Installation
¥ Brass or Black Door Frame
¥ Brass, Black, or Cast Legs or Pedestal

Order of Installation

1 If the heater is to use propane, follow the instructions on pages 28 - 34.
2 Attach the legs or pedestal (see page 24) and optional equipment (if applicable)
3 Position the heater (measure clearances from the upper top), use floor protection if needed
4 Connect the gas line
5 Connect the gas vent
6 Follow the instructions under "Finalizing the Installation" on pages 9 through 13.

Stove Clearances

Straight Installations
10" Min.
+ Clearances may be reduced by methods specified in NFPA 211, listed wall shields, pipe shields, or
other means approved by local building or fire officials.
I
NSTALLATION
When installed with this
clearance, the vent is
6-1/2" from the back
wall, 19-3/4" from the
side wall.
-
For qualified installers only!
¥ Door Kit (Door handle, mounting angle, T-nut)
¥ Propane Conversion Kit
¥ Gas Inlet (3/8" Pipe)
When installed with this clearance, the
vent is 13" from the wall.
4" Min.
Corner Installations
4" Min.
45¡