Stove Installation; Installation Preparation; Items Required For Installation; Items Packed With The Heritage Bay - Lopi Heritage Bay DV Owner's Manual

S
TOVE
P 6
AGE

Installation Preparation

! Failure to follow all of the requirements may result in property damage, bodily injury, or even
death.
! This appliance must be installed in accordance with all local codes, if any; if not, follow ANSI
Z223.1 and NFPA 54(88).
! In Manufactured or Mobile Homes must confirm with: In USA, Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part 3280; In Canada, CSA Z240.4 and Gas-Equipped
Recreational Vehicles and Mobile Housing. This appliance may be installed in Manufactured
Housing only after the home is site located.
! This appliance is designed for natural gas or propane (LP). Check the sticker on top of the gas
control valve.
! All exhaust gases must be vented outside the structure of the living-area. Combustion air is drawn
from outside the living-area structure.
! Notify your insurance company before hooking up this appliance.
! The requirements below are divided into sections - all requirements must be met simultaneously.
ems Required for Installation
¥ Simpson Duravent (see page 8 for part #'s) & Silicone
ems Packed with the Heritage Bay
¥ Heritage Bay
¥ Propane Conversion Kit
rder of Installation
1 If using propane, follow the converstion instructions on
page 28
2 Position the heater, use floor protection if needed

Stove Clearances

Straight Installations
8" Min.
(200 mm)
I
NSTALLATION
With this clearance the vent
is 6" (152 mm) from the back
wall, 18-3/4" (476 mm) from
the side wall.
- For Qualified Installers Only!
¥ Gas Hookup Equipment
¥ Log Set (2 Logs, 2 Twigs, Embers)
3 Connect the gas line. Connect the gas vent.
4 Follow the instructions under "Finalizing the
Installation" on pages 14 through 16
3" Min.
(75 mm)
Corner Installations
With this clearance, the vent is
10-3/4" (273 mm) from the wall.
3" Min.
(75 mm)
45¡