Lopi Spirit B-Vent Gas Stove Owner's Manual page 29

7 Replace the pilot assembly (follow the instructions in step 6 in reverse order). Make sure the pilot
assembly gasket is placed correctly.
8 Replace the rear log shelf (see step 2). Install the logs and embers. Replace the glass and door.
9 Remove the regulator from the front of the gas control valve. Replace with the propane regulator,
using the new gasket and screws included with the regulator. NOTE: Leak test this area after the
heater is installed, gas is connected, and the main burner is lit.
Align the regulator
gasket so it is flat
and the two tabs fit
through the two
holes on the
gasket.
PILOT ADJ
10 Place the included propane label over the natural gas label on top of the gas control valve.
11 Make the gas line connection, start the heater and thoroughly leak-test all gas connections
and the regulator. Check the pilot. Adjust if necessary.
The pilot flame should impinge the top 3/8Ó of the
thermopile. If it does not, you may need to turn
the pilot up.
3/8Ó
O
PTIONAL
NOTE: These holes strip
easily. Use a hand
screwdriver and tighten
each screw evenly.
Thermopile
Pilot Hood
Thermocouple
E
QUIPMENT
These screws hold the
regulator in place.
NOTE: use the new
screws included with
the regulator.
Phillips
Screwdriver
Regulator Gasket
NOTE: use the new gasket
included with the regulator.
THIS CONTROL
HAS BEEN
CONVERTED TO
LP
To adjust the pilot flame, remove the cover screw (and
gasket) and turn the needle valve. Clockwise lowers
the flame while counter-clockwise raises it.
Cover Screw Gasket
The cover screw and
gasket must be
replaced to prevent gas
from leaking
(C )
ONTINUED
LP (propane) regulators have a
11.0 2.8 stamped here.
Needle Valve
Micro (1/16Ó)
Standard
Screwdriver
PILOT ADJ
Cover Screw
Standard
Screwdriver
P 29
AGE