Troubleshooting Table - Lopi Spirit B-Vent Gas Stove Owner's Manual

Problem:
Pilot Will Not Light
Main Burners Will Not
Start
Remote Control Does
Not Work
Thermostat Does Not
Work
Blower Will Not
Distribute Heat
Pilot Goes Out Once A
Month Or More
Flame (and Pilot) Goes
Out 10 to 25
Minutes After
Starting
Flames Are Too Blue
Flames Are Orange
With Dirty Smoke
Flames Are Too Short
(Under 6")
Thin Layer of Soot
Covers the Glass
Possible Cause:
A gas shut off valve is turned off
The valve control knob isn't turned to "PILOT"
The valve control knob isn't pushed in
The igniter wasn't pressed repeatedly
The pilot light has gone out
The ON/OFF switch is turned to "OFF"
The remote control is not working correctly
The thermostat is disconnected or set too low
The pilot light has gone out
The ON/OFF switch is turned to "OFF"
The remote is too far away from the heater
The remote control receiver is turned "Off" or "On"
One of the two remote control batteries is dead
The pilot light has gone out
The ON/OFF switch is turned to "OFF"
The thermostat is set too low
The heater is unplugged
The heater is not up to temperature
The gas supply has been shut off
The vent is experiencing a cold air blockage or a negative
pressure situation exists in the home
The vent is experiencing a cold air blockage or a negative
pressure situation exists in the home
The heater has just been started
Improper air shutter adjustment
Something may be placed against the heater
Improper air shutter adjustment
The flame height may be turned too low
Something may be placed against the heater
The logs are placed incorrectly
Improper air shutter adjustment
T
ROUBLESHOOTING
Don't Call for Service
Until You:
Check all gas shut off valves
See "Starting the Pilot Light" Step C
See "Starting the Pilot Light" Step C
See "Starting the Pilot Light" Step C
See "Starting the Pilot Light"
Turn the ON/OFF switch to "ON"
See the remote control instructions
See "Thermostat Operation"
See "Starting the Pilot Light"
Turn the ON/OFF switch to "ON"
Use the remote closer to the heater
See the remote control instructions
See the remote control instructions
See "Starting the Pilot Light"
Turn the ON/OFF switch to "ON"
See "Thermostat Operation"
Plug the heater in.
See "Operating Your Heater"
Keep the gas supply turned on
This is a necessary safety feature that
disables the heater if a down draft occurs.
If this problem is persistent the vent may
need to be improved or changes may need
to be done to remove the negative pressure
inside the home - see your dealer for
details
This is a necessary safety feature. First try
restarting the heater. If it works correctly,
a cold air blockage occurred and the vent
just needed to be heated sufficiently. If
this problem is persistent the vent may
need to be improved or changes may need
to be done to remove the negative pressure
inside the home - see your dealer for
details
Normal - see "Operating Your Heater"
Adjust Air Shutter - contact your dealer
See "How this Heater Works"
Adjust Air Shutter - contact your dealer
Turn the flame height to "HI" -
See "Operating Your Heater"
See "How this Heater Works"
See "Installing the Logs and Ember Strip"
Adjust Air Shutter - contact your dealer
P 19
AGE