Troubleshooting Table; Location Of Fuses; Replacement Parts List - Lopi NorthField GSR2 Deluxe Owner's Manual

Maintenance
46

Troubleshooting Table

Problem:
Burner Will Not Start
Appliance Beeps
Thermostat Does Not
Work
Blower Does Not
Work
Stove Will Not
Distribute Heat
Flames Are Too Blue
Flames Are Too
Short (Under 6")
Thin Layer of Soot
Covers the Glass
Accent Lights
Do Not Work

Location of Fuses

The two 3 amp fuses are under the concealment cover (see page 36).

Replacement Parts List

Caution: Use only Travis Industries replacement parts. Do not use substitute materials.
Warning: Do not operate appliance with the glass front removed, cracked, or broken. Replacement of
the glass should be done by a licensed or qualified service person.
Contact your local Travis Industries Dealer for a Replacement Parts List
© Travis Industries
(for qualified service personnel only)
Possible Cause:
The battery box switch is turned to "OFF"
The remote control is not working correctly
The thermostat is disconnected or set too low
No propane in tank
Heater beeps once:
The heater beeps once whenever a button on the
remote is pressed
Heater beeps twice:
The heater beeps twice whenever a button on the
remote is pressed
The battery box switch is turned to "OFF" or "ON"
The thermostat is set too low
The stove is not getting electricity
The stove is not up to temperature .......................
The blower fuse may be blown
The stove is not getting electricity
The stove is not up to temperature
The stove has just been started
Improper air shutter adjustment
The flame height may be turned too low
Log set is placed incorrectly
Improper air shutter adjustment
The bulb may be burned out. ................................
The accent light fuse may be blown. ....................
Fan Fuse (3 amp)
Light Fuse (3 amp)
Turn the battery box switch to "ON".
See the remote control instructions.
See "Thermostat Operation".
Check Tank Level.
THIS IS NORMAL
The power backup batteries are low.
Replace the 4 AA batteries in the battery
box (see page 42).
Turn the battery box switch to "REMOTE".
Check thermostat.
Check the breaker switch.
Let the stove burn for 10 minutes.
Replace the fuse. See fuse location below.
Check the breaker switch.
Let the stove burn for at least 15 minutes.
This is normal - see "Starting the Stove for
the First Time".
Adjust Air Shutter - contact your dealer.
Turn the flame height to "HI" -
See "Adjusting the Flame Height".
See page 30.
Adjust air shutter - contact your dealer.
See "Accent Light Replacement" page 45.
Replace the fuse. See fuse location below.
4160713
Don't Call for Service Until
You:
100-01442