Cancelling Route Guidance; Resuming Route Guidance After Cancelling; Detour Function - Mercedes-Benz COMAND Operator's Manual

Navigation
Route guidance
The message "The driving instructions
have been muted" appears briefly.
To switch navigation announce-
ments back on again manually: Se-
6.
lect "Navi"
K
or
In the map display with the menu sys-
tem displayed ( page 119) select
6.
or
Start new route calculation
( page 135).
or
If you switch COMAND on again or
start the engine.
To set the volume of the announce-
ments: Set the volume during an auto-
matic announcement Setting the
volume ( page 35).
or
Call up an announcement manually us-
6 and set the volume
ing "Navi"
K
( page 35).
154

Cancelling route guidance

In the map display with the menu sys-
tem displayed ( page 119) select
"Destination" "Cancel Route
K
Guidance".
Resuming route guidance after
cancelling
In the map display with the menu sys-
tem displayed ( page 119) select
"Destination" "Continue Route
K
Guidance".
COMAND calculates the route.

Detour function

i
The Detour function blocks a route segment
ahead. You can set the length of the block.
COMAND calculates a detour route if possible.
In the map display with the menu sys-
tem displayed ( page 119) select
"Route" "Detour".
K
To set length of block: Select
"Longer" or "Shorter" repeatedly until
the required length is set.
The blocked segment is highlighted in
red/white on the map. Shown at the
top of the display is the length of the
blocked segment and the route seg-
ment to which the block goes.
To cancel the function: Select "Back".
To start route calculation: Select
"Start", see also ( page 135).
To change a block: Select "Navi"
"Route" "Detour" "Change".
K K
i
If a block already exists, the message "De-
tour Already Set" is displayed. You can then
change or delete this.
Then set length of block.
To delete block: Select "Navi"
"Route" "Detour" "Delete".
K K
i
If a block already exists, the message "De-
tour Already Set" is displayed. You can then
change or delete this.
K
K