Entering A Destination From The Desti- Nation Memory - Mercedes-Benz COMAND Operator's Manual

Starting route calculation
i
Route calculation can only be started once
all the necessary address data has been en-
tered.
In the Enter Destination menu select
"Start".
1 Destination
2 Starts route calculation and then starts
route guidance
If route guidance is not active yet, the
route calculation is started.
If route guidance is already active, you
will be prompted to confirm that route
guidance should be ended.
Select "Yes" or "No".
If you select "Yes" COMAND cancels
route guidance and starts the route cal-
culation to the newly entered destina-
tion.
If you select "No" COMAND resumes
the active route guidance.
During the route calculation, an arrow
points towards the destination, and un-
derneath the message "Calculating
Fast Route...", for example, is dis-
played.
Route guidance begins after the route
has been calculated ( page 148).
i
Route calculation takes some time. The
length of time depends on, e.g. distance to the
destination. COMAND calculates the route using
the digital map data. The calculated route may
deviate from the actual road situation, e.g. as a
result of road works or incomplete map data.
Please refer to the information on the digital map
( page 112).
Navigation
Destination input
Entering a destination from the des-
tination memory
If necessary switch to navigation mode
and display menu system
( page 118).
Select "Destination" "From Memo-
K
ry".
If there are more than 8 entries in the
destination memory, the destination
memory list with predictive speller
( page 136) is displayed, otherwise
the destination memory list is dis-
played without predictive speller
( page 137).
i
There is always an entry in the destination
memory with the name "My Address". You can
assign your home address, for example, to this
entry and select it for route guidance
( page 157). This entry is at the top of the list
in the destination memory.
135