Mercedes-Benz COMAND Operator's Manual page 124

A checked entry indicates an active
blocked area.
i
You can block several areas for the route
calculation and activate or de-activate them by
setting or removing the check mark.
Displaying and changing an existing
block area
To select the area you want to dis-
play or change: Slide qmr.
Select "Display/Change".
The map display appears with the block
area marked red.
ymz
Rotate until the desired size of
the block area is set.
Slide qmr, omp wmx
or
block area to the desired region.
To confirm the area and exit map
display: Press n.
Hide menu system if applicable
( page 119).
Defining a new Block area
Select "Avoid New Area".
The map display appears with a default
new block area in red.
ymz
Rotate
the new block area is set.
Slide qmr,
new block area to the desired region.
To confirm the area and exit map
display: Press n.
Hide menu system if applicable
( page 119).
Deleting a block area
To select the area you want to de-
lete: Slide qmr.
Select "Options"
You will be prompted to confirm that
you wish to delete the block area.
Select "Yes" or "No".
to shift the
until the desired size of
omp wmx
or to shift the
"Delete".
K
Navigation
Introduction
If you select "Yes" COMAND deletes
the entry. A message will be displayed.
Information on map
You can have map information displayed at
the bottom edge of the screen during route
guidance.
To set: Display menu system if applica-
ble ( page 119).
Select "Navi" "Information On Map".
K
A dotR indicates the current setting.
Select "Arrival Time / Distance" or
"Current Street" or "Geo-coordinates"
or "None".
To exit menu: Slide omp.
Hide menu system if applicable
( page 119).
123