Entering A Poi Via The Map - Mercedes-Benz COMAND Operator's Manual

Entering a POI via the map

i
If the crosshairs are visible on the map, you
can enter POIs in the vicinity of the crosshairs.
If the crosshairs are not visible, you can enter
POIs in the vicinity of the current vehicle loca-
tion.
In the map display with the menu sys-
tem displayed ( page 119) select
"Guide".
POIs are available:
Depending on the map scale selected,
POI symbols are displayed on the map.
The scale starting at which symbols are
displayed on the map varies from sym-
bol to symbol.
You can select which symbols
COMAND should display ( page 121).
The POI nearest to the center of the
screen is selected automatically.
No POIs available:
A corresponding message is displayed.
i
This message is also displayed if the menu
item "No Symbols" under "Map Display" has
been selected ( page 121).
To confirm message: Press n.
1 Information about the highlighted POI
2 Highlighted POI
Navigation
POI input
To select a POI: Select "Next" or
"Previous".
To display details on the selection:
Select "Details".
To start route calculation: Select
"Start", see also ( page 135).
You will be asked whether the POI
should be adopted as the destination.
Select "Yes" or "No".
Route calculation starts if "Yes" is se-
lected; a new POI can be chosen if "No"
is selected.
147