Mercedes-Benz COMAND Operator's Manual page 115

Navigation
Introduction
Update process
The update process starts once the DVD
has been loaded.
COMAND checks whether the map soft-
ware on the DVD matches the vehicle's
navigation system and system software.
Map software is not suitable for the
navigation system or the system soft-
ware
A message is displayed stating that the
navigation update DVD with the new map
data is not suitable for the system or the
system software.
COMAND ejects the DVD.
Remove the DVD from the slot 1.
Have the system software updated by
an authorized Mercedes-Benz Center.
i
It will only be possible to update the map
software once the system software has been up-
dated.
Map software matches the navigation
system and the current system software
COMAND checks whether the DVD's map
data has already been installed.
114
Map data is already installed
The version release and a corresponding
message will be given on the display.
To confirm message: Press n.
COMAND ejects the DVD.
Map data is not yet installed
The version release and a query as to
whether the update should be carried out
will be given on the display.
Select "Yes" or "No".
If "No" is selected, COMAND ejects the
DVD automatically and the map data is
not updated.
Remove the DVD from the slot 1.
If "Yes" is selected, the map data is up-
dated.
Updating the map data
While the update is in progress, a corre-
sponding message and a progress bar are
displayed. The progress bar fills from left
to right over the course of the update. The
navigation system is not functional until
the update is complete.
You cannot eject the DVD during the up-
date. If you switch COMAND off during the
update, this will interrupt the update and
the update will resume at the point of inter-
ruption when the system is restarted.
While updating, COMAND may prompt you
to change the DVD. A corresponding mes-
sage is then displayed.
u
Press the Eject button
COMAND ejects the DVD.
Remove the DVD from the slot 1.
Insert the DVD requested by COMAND.
If the update has been completed suc-
cessfully, a corresponding message is
displayed.
To confirm message: Press n.
COMAND ejects the DVD.
Remove the DVD from the slot 1.
The update is complete.
If the update has not been completed suc-
cessfully, a message is displayed indicat-
ing that the map update is not possible.
To confirm message: Press n.
COMAND ejects the DVD.
Remove the DVD from the slot 1.
.