Mercedes-Benz COMAND Operator's Manual page 123

Navigation
Introduction
To exit menu: Slide omp.
Hide menu system if applicable
( page 119).
Route mode
This functions allows you to set the follow-
ing options for route guidance:
"Avoid Highways"
"Avoid Toll Roads"
"Avoid Tunnels"
"Avoid Ferries"
"Avoid AutoTrains"
1 Sets route options
Setting route options
122
To set: Display menu system if applica-
ble ( page 119).
Select "Navi" "Mode".
K
To switch option on/off: Select re-
quired option.
Depending on the previous status, the
option will be switched on D or off C.
You may activate several options.
i
The calculated route may include ferry con-
nections, for example, even if the option "Avoid
ferries" has been activated.
i
If you change the route type setting when
route guidance is active, COMAND calculates a
new route.
Block Area
You can define an area within the map dis-
play that is not to be used by the system in
calculating a route, if possible.
i
The calculated route may include a blocked
area if the destination is within a blocked area or
if the destination can only be reached using
roads that lead through a blocked area.
To set, change or delete: Display
menu system if applicable
( page 119).
Select "Navi" "Block Area".
K
If no areas were previously set, the
map display appears ready to select
an area.
Slide qmr, omp wmx
or to select an
area.
Press n.
The blocked area appears in red.
ymz
Rotate to change the size of the
blocked area.
Press n.
The area is added to the blocked area
list