Electrolyte Alarm - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

Electrolyte Alarm (Optional)
1. Make sure the key-switch is in the "OFF" position, then remove
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
5. Disconnect the main positive and negative cables at the
6. If the Electrolyte warning alarm is sounding or the LED light is red,
then the batteries need servicing.
7. Using the appropriate procedure, service and charge all the batteries.
8. Take the Electrolyte alarm unit out of the battery cell, wipe the electrode clean,
and put the unit back in the battery.
NOTE: The wiring for the Electrolyte alarm does not need to be disconnected
Be sure the Electrolyte alarm electrode does not contact the top
of the battery plates. If the electrode contacts the plates, the
alarm will not function correctly and may damage the alarm and or
the battery.
E L E C T R O - L i g h t i n t y p i c a l b a t t e r y
TM
p a c k
the key.
movement.
batteries.
A battery is a live electrical source. It cannot be
disconnected or neutralized. Do not drop any metal
tool or conductive object onto the battery. A con-
ductive object that comes in contact with the bat-
tery terminals or exposed wiring may initiate a short
circuit of the battery or cause an explosion. The
result may damage property and or cause serious
bodily injury.
from the batteries.
9. When the batteries have been serviced and
charged the alarm will stop and the LED will
be green.
10. Reconnect the main positive and negative
11. Remove the blocks from behind the wheels.
12. Release the park brake and test drive the
vehicle.
SECTION 3
cables at the batteries.
PAGE 63
MB-T48-01
ELECTRO -Light
TM