Filling and Checking the Fluid Level
1. Make sure the key-switch is in the "OFF" position, then remove
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
5. Disconnect the main positive and negative cables at the
6. Clean the cover and exterior of the master cylinder
and the surrounding area.
7. Remove the cap from the top of the master cylinder
and visually check the level of fluid.
8. Add DOT 3 brake fluid as needed, fill level 1/4" from
the top of the master cylinder.
9. Replace the cap on the master cylinder.
10. Reconnect the main positive and negative cables at
the batteries.
11. Remove the blocks from behind the wheels.
12. Release the park brake and test drive the vehicle.
the key.
movement.
batteries.
SECTION 3
PAGE 15
MB-T48-01