MB-T48-01
Repairing the Front Axle
Steering Yoke/Bushings
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.
6. Raise the front of the vehicle and support with jack stands.
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle. Failure
to use lifting and support devices of rated load capacity
may result in serious bodily injury.
7. Remove the wheel.
8. Remove the hydraulic brake body.
Do not let the brake body hang by
the brake hose. Support the brake
body to prevent damage to the
hose.
9. Remove the drag link and/or tie rod from the yoke.
SECTION 3
PAGE 22