Assembly Of The 3Rd Member - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

MB-T48-01
Disassembling the 3rd Member
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.
6. Raise the rear of the vehicle and support with jack stands.
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle. Failure
to use lifting and support devices of rated load capacity
may result in serious bodily injury.
7. Remove the complete drive from the vehicle.
8. Drain the oil from the 3rd member and gear case into an appropriate
receptacle.
9. Place the 3rd member on an appropriate stand.
10. Remove the axle shafts and tubes as an
assembly from the 3rd member by removing
the six axle tube flange bolts on each axle tube.
11. Using the appropriate procedure, remove the
primary reduction gear case.
12. Remove the 12 side plate bolts, then remove
the side plate.
SECTION 3 PAGE 42