Storing And Returning To Service; Returning To Service - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

MB-T48-01

Storing and Returning to Service

1. Make sure the key-switch is in the "OFF" position, then
remove the key.
2. Place the forward-reverse switch in the center "OFF"
position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Use personal protective equipment when working with
batteries.
• Clean batteries, fill, and charge before putting the vehicle in stor-
age. Do not store batteries in a discharged condition.
Lube all grease fittings.
•
• Clean, dry, and check all exposed electrical connections.
Inflate tires to proper pressure(if applicable).
•
For extended storage, the vehicle should be elevated so that the
•
tires do not touch the ground.
Storage Temperature
Below 40° F
40° - 60° F
Above 60° F
If stored for a prolonged period, the batteries should be
charged as follows:

Returning To Service

Check state of battery's charge. (Charge if needed)
Perform ALL maintenance checks in the periodic checklist.
Remove any blocks from the vehicle and/or place the vehicle
on the down on to the ground.
Test drive before putting into normal service.
Charge
Every 6 months
Every 2 months
Once a month
SECTION 2 PAGE 14