Automatic Electric Brake Removal And Installation - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

Automatic Electric Brake Removal and Installation

In the event, a vehicle equipped with, an automatic electric brake unit becomes immobile.
Tow the vehicle with the rear axle hoisted and secured in the air to the maintenance
facility were an authorized technician can begin any necessary repairs.
It is not necessary to remove the drive assembly to perform the removal and installation
of the electric brake in most cases. However, if the vehicle is equipped with an optional
cargo box, it may be necessary to lower the drive assembly in order to access the motor.
1. Make sure the key-switch is in the "OFF" position, then remove
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
5. Disconnect the main positive and negative cables at the
6. Remove the wires from the motor and disconnect the automatic electric brake
wires.
NOTE: Label the wires connected to the motor to insure that they are
returned to their proper location on the motor during reassembly.
7. Remove the motor mounting bolts and the motor support bracket u-bolt
from the drive and slide the motor off of the input shaft of the automatic
electric brake.
Do not remove the motor and brake as an assembly. Remove the
motor from the brake leaving the brake on the input shaft to the
drive then remove the brake from the drive. If you remove the
motor and brake as an assembly, the brake may slide off of the
motor shaft and may fall to the ground damaging the brake.
Motor and Automatic Electric Brake Assembly
the key.
movement.
batteries.
SECTION 3
MB-T48-01
PAGE 55