Removing The Rear Axles - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

MB-T48-01

Removing the Rear Axles

This procedure does not require that the rear end or drive assembly be removed
from the vehicle.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.
6. Drain the oil.
Always use a lifting strap, hoist, and jack stands, of adequate
capacity to lift and support the vehicle. Failure to use lifting and
support devices of rated load capacity may result inserious bodily
injury.
7. Raise the rear of the vehicle and support with jack stands.
8. Release the park brake.
9. Remove the tire and wheel assembly.
10. Remove the four bolts attached to the axle retaining plate.
11. Remove the axle retaining plate and brake body assembly as one unit.
If the bearings are removed from the axle, the axle retainer and
bearings must be replaced with new ones. Failure to replace these
parts could result in the axle coming out of the vehicle while driving
and may result in serious bodily injury.
12. Secure the brake body assembly, do not let it hang by the brake hose.
13. Pull the axle out of the housing.
14. Inspect all bearings for roughness or play, replace as needed.
15. Install in reverse order, lubricate the o-ring.
NOTE: Be sure not to damage the o-ring.
SECTION 3 PAGE 36